Waterbug wb200 manual

The WaterBug® 200 is a water detection device ideal for computer rooms, document storage areas, warehouses, sump pumps and basements, etc. WaterBug sensors activate the alarm when a conductive bridge is formed between 2 contacts. Protect your assets with the WB-200. Resources WB200_brochure WB200_Manual . Winland WB-200 WaterBug Moisture Detection System; Also known as: WB200, WI-WB200; UPC: 082075001045 Also known as: WI-WB200 The WINLAND-WB-200 is an electrical water detector that offers wide area of coverage and can detect nonflammable conductive liquids. The WB-200 is designed so that the control console mounts on a wall or other at vertical surface and the remote probes are placed in the Description. The Winland Electronics WaterBug® 200 (WB-200) is a water detection device ideal for computer rooms, document storage areas, warehouses, sump pumps and basements. WaterBug sensors activate the alarm when a conductive bridge is formed between 2 contacts. The WB-200 is designed to be connected to any hardwired alarm system. The standard surface water probe is unsupervised and can be connected to the full line of WaterBug products only. Alarm will sound when water is detected but no alarm will sound if the cable is cut. Additional surface sensor for the WaterBug 200 or WaterBug 350 models. Waterbug WB200 water/flood detector $59.99 This product is currently out of stock Product Information NOS Waterbug WB200 by Winland Electronics. Electrical contacts detect water before there is a flood condition. Can be powered by any 12VDC alarm panel to provide an alarm when water is detected. Sensors can be up to 200' from the control module. WaterBug® sensors work by forming a conductive bridge between to contacts. Use in conjunction with alarm panel, bell, wireless transmitter, etc. Connect as many as 6 sensor probes up to 100' (30.48 m) away from the console for wide area protection. Features Includes 1 sensor (W-S-U) with 15' (4.57 m) cable. Simultaneously monitor up to 6 zones. The Winland WB200 is a wired flood sensor. It connects directly to a wired panel and uses an attached probe to detect leaks or floods. The sensor activates once a conductive bridge is formed between two (2) contacts on the probe. Includes one WB200 Console w/ one unsupervised surface sensor. We were unable to load Disqus Recommendations. WB350 - stand-alone water bug alert console designed for stand-alone operation powered by a 9V battery with low battery indicator ideal for office environments or near water heaters includes one standard surface sensor built-in buzzer triggers when water is present WB200 - hardwire water bug alert console unit must be Hardwired to 12 or 24 V This WB200 depicts: power pulled from security Open (NO,) Wiring 6 surface sensors (W-S-U) (WS-S) do not to this device notification (we recommend the SZ- IJ XMATERBUS WINLAND INC. 0000000 GND S S C NO NC The WaterBug sensors are not polarity sensitive, Win land 1950 Excel Drive Mankato, MN 56001 800.635.4269 WWW.WINLAND.COM The model WB-200 operates on 12 or 24 Volt AC/DC and has a form C relay output that can be connected to alarm panels, bells, dialers, etc. The unit can monitor up to as many as six sensor probes wired in parallel, up to 100 feet away using 22-18 AWG twisted pair. Each sensor probe has two contacts. $59.99 Availability: In Stock. The relay offers both normally open and normally closed connections. The Waterbug WB200 includes one water se