Victaulic couplings pdf notes

NOTES • Victaulic reserves the right to substitute equivalent and/or higher grade elastomer products. • For additional gasket grades reference publication 06.23 for the Style 107N • Victaulic RX roll sets must be used when grooving light-wall/thin-wall stainless steel pipe for use with Victaulic Couplings. • victaulic, the originator and innovator of grooved coupling technology, offers a variety of coupling sizes and styles for fire protection piping systems • victaulic developed the first ul listed coupling in 1952 and continues to develop products that allow for faster and easier joining of pipe … Coupling Gasket: (specify choice1) ™Victaulic Grade "E" FlushSeal EPDM EPDM (Green stripe color code). Temperature range -30ºF to +230ºF/-34ºC to +110ºC. May be specified for hot water service within the specified temperature range plus a variety of dilute acids, oil-free air and many chemical services. Flexible Coupling_Nasir Zulfiqar.pdf. b. Modeling Victaulic Flexible coupling Method-2_Rev 01.pdf. Note: 1. Modeling every flexible coupling in a model (say 10 or more flexible couplings) could be a cause of nonlinear convergence issues. 2. Style 77 couplings are designed with cross-ribbed construction to provide a strong component for pressure piping systems. The coupling is offered in a two piece housing design from ¾ − 24"/20 − 600mm sizes for pressures up to 1000 psi/6900 kPa. All sizes are provided with plated bolts and nuts. NOTES • Refer to Victaulic submittal publication 10.01 for details 6 Couplings 8, 10, 12"/200, 250, 300 mm sizes available to JIS standards. Refer to Victaulic submittal publication 06.17 for details. 7 For 14 - 72"/350 - 1800 mm Roll Groove systems Victaulic offers the Advanced Groove System (AGS) line of products. NOTES • ™Style W07 AGS couplings are provided with FlushSeal gaskets for a variety of services. Please specify gasket grade when ordering. Please refer to publication 05.01 for gasket service ratings. • Style W07 AGS rigid couplings can also be used on abrasive/slurry services in combination with an AGS Vic-Ring. See publication 16.11. General Notes HP-70ES couplings cannot be used with Victaulic Series 700 butterfly valves. HP-70ES couplings must always be used with pipe or fittings grooved to Victaulic "ES" dimensions. Metric thread size bolts are available (color coded gold) for all coupling sizes upon request. Contact Victaulic for details. NOTES: 1.ictaulic ring to Refer to Victaulic publication 15.03, which can be downloaded at victaulic.com P style 809n coupling installation, 809n coupling installation, 809n coupling assembly toruqes, 809n couplings reassembly, removing rings clamps, square cut pipe ends Created Date: These rigid couplings provide a rigid joint allowing no expansion/contraction or linear movement. Couplings will push the pipe ends to their maximum allowable separation which must be considered during assembly. Rigid couplings (Styles 07, W07, 89, 489, 307, HP-70, 741, W741 and others) create a rigid joint, useful NOTES • When assembling Style 009N or Style 109 couplings onto end caps, take additional care to make certain the end cap is fully seated against the gasket end stop. For Style 009N or Style 109 couplings, use FireLock No. 006 end caps containing the "EZ" marking on the inside face or No. 60 end caps containing the NOTES • When assembling Style 009N or Style 109 couplings onto end caps, take additional care to make certain the end cap is fully seated against th